Gigabyte GA-VM800PMC User Manual page 64

(3) Configuring RAID set in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed to Section 4 if
you do not want to create RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, the following
information will appear on screen (Figure 3). Press the TAB key to enter the VT8237 Serial ATA RAID
BIOS configuration utility.
VIA Technologies, Inc. VIA VT8237 Serial ATA RAID BIOS Setting Utility V4.97
Copyright (C) VIA Technologies, Inc. All Right reserved.
Scan Devices, Please wait...
Press <Tab> key into User Window!
Serial_Ch0 Master : ST3120026AS
Serial_Ch1 Master : ST3120026AS
Step 2:
In the VT8237 SATA RAID BIOS utility screen (Figure 4), you can use the UP or DOWN ARROW key
to highlight through choices. Highlight an item that you want to execute and press ENTER.
Create Array
Delete Array
Create/Delete Spare
Select Boot Array
Serial Number View
Channel Drive Name
Serial_Ch0 Master ST3120026AS
Serial_Ch1 Master ST3120026AS
GA-VM800PMC Motherboard
Figure 3
VIA Tech. VT8237 SATA RAID BIOS Ver 4.97
Create a RAID array with
the hard disks attached to
VIA RAID controller
F1
Enter : Confirm the selection
ESC
Array Name
Figure 4
- 64 -
: View Array/disk Status
, : Move to next item
: Exit
Mode Size(GB)
SATA 111.79
SATA 111.79
Status
Hdd
Hdd