Gigabyte GA-VM800PMC User Manual page 62

(2) Configuring SATA controller mode and boot sequence in BIOS Setup
You have to make sure whether the SATA controller is configured correctly in system BIOS Setup and
set BIOS boot sequence for the SATA hard drive(s).
Step 1:
Turn on your computer and press Del to enter BIOS Setup during POST (Power-On Self Test). If you
want to create RAID, select SATA Mode under the Integrated Peripherals menu (Figure 1) and set
this item to RAID (IDE by default). Set SATA Mode to IDE if you do not want to create RAID.
CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
OnChip IDE Channel 0
OnChip IDE Channel 1
VIA Onboard LAN
OnBoard LAN Boot ROM
OnChip Serial ATA
SATA Mode
AC97 Audio
USB 1.1 Controller
USB 2.0 Controller
USB Keyboard Support
USB Mouse Support
Legacy USB storage detect
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
x EPP Mode Select
: Move Enter: Select
F5: Previous Values
The BIOS Setup menus described in this section may not show the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
GA-VM800PMC Motherboard
Integrated Peripherals
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
[RAID]
[Auto]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
EPP1.7
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults F7: Optimized Defaults
Figure 1
- 62 -
Item Help
Menu Level
ESC: Exit F1: General Help