Gigabyte GA-K8VNXP User Manual page 44

Floppy 3 Mode Support (for Japan Area)
Disabled
Drive A
Drive B
Both
Halt on
The category determines whether the computer will stop if an error is detected during power up.
NO Errors
All Errors
All, But Keyboard
All, But Diskette
All, But Disk/Key
Memory
The category is display-only which is determined by POST (Power On Self Test) of the BIOS.
Base Memory
The POST of the BIOS will determine the amount of base (or conventional) memory
installed in the system.
The value of the base memory is typically 512 K for systems with 512 K memory
installed on the motherboard, or 640 K for systems with 640 K or more memory
installed on the motherboard.
Extended Memory
The BIOS determines how much extended memory is present during the POST.
This is the amount of memory located above 1 MB in the CPU's memory
address map.
GA-K8VNXP Motherboard
Normal Floppy Drive. (Default value)
Drive A is 3 mode Floppy Drive.
Drive B is 3 mode Floppy Drive.
Drive A & B are 3 mode Floppy Drives.
The system boot will not stop for any error that may be detected
and you will be prompted.
Whenever the BIOS detects a non-fatal error the system will be stopped.
The system boot will not stop for a keyboard error; it will stop for
all other errors. (Default value)
The system boot will not stop for a disk error; it will stop for all
other errors.
The system boot will not stop for a keyboard or disk error; it will
stop for all other errors.
- 44 -