9) IDE3 / IDE4 (RAID/ATA133, Green Connector)
Important Notice: The red stripe of the ribbon cable must be the same side with the Pin1. If you wish
to use IDE3 and IDE4, please use it in unity with BIOS (either RAID or ATA133). Then, install the
correct driver to have proper operation. For details, please refer to the GigaRAID manual.
10) SATA0 / SATA1 (Serial ATA Connector)
You can connect the Serial ATA device to this connector, it provides you high speed transfer rates
(150MB/sec). If you wish to use RAID function, please use it in unity with BIOS and install the
correct driver to have proper operation.
39
40
Pin No.
1
7
SATA0
1
7
SATA1
- 29 -
Hardware Installation Process
1
IDE4
IDE3
2
Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND