Table of Contents
Advertisement
Troubleshooting
If you encounter any trouble during boot up, please follow the
troubleshooting procedures .
Turn off the power and unplug the AC power cable, then remove
all of the add-on cards and cables from motherboard.
Please make sure motherboard & chassis are not short ?
Please make sure all jumper settings (such as CPU system bus
speed, frequency ratio, voltage and etc.) are set properly.
Check if the CPU cooling fan attached to CPU properly. ls
CPU cooling fan power connected to CPU_FAN
Check if the memory install properly into the DIMM slot.
Insert the VGA card. Then plug in ATX power cable and turn
on the system.
GA-7VAX/GA-7VAXP Motherboard
START
No
Yes
properly?
Yes
Yes
A
- 104 -
Yes
Please isolate
the short pin.
Failure has been ex cluded.
Make sure the
No
jumper setting
are correct.
Failure has been ex cluded.
No
Failure has been ex cluded.
No
Failure has been ex cluded.
Advertisement
Table of Contents
