Appendix A: Faq - TP-Link TD-W8950ND User Manual

TD-W8950ND

Appendix A: FAQ

1. How do I configure the Router to access Internet by ADSL users?
1) First, configure the ADSL Modem configured in RFC1483 bridge model.
2) Connect the Ethernet cable from your ADSL Modem to the WAN port on the Router. The
telephone cord plugs into the Line port of the ADSL Modem.
3) Log in to the Router, and configure the WAN connection type as PPPoE connection mode.
The detailed steps please refer to section 4.5.1.
4) If your ADSL lease is in "pay-according-time" mode, select "Dial on Demand" for Internet
connection mode.
Note:
If you are a Cable user, please configure the Router following the above steps.
2. The wireless stations cannot connect to the Router.
1) Make sure the "Enable Wireless Router Radio" is checked.
2) Make sure that the wireless stations' SSID accord with the Router's SSID.
3) Make sure the wireless stations have right KEY for encryption when the Router is encrypted.
4) If the wireless connection is ready, but you can't access the Router, check the IP Address of
your wireless stations.
150Mbps Wireless Lite N ADSL2+ Modem Router User Guide
78