Managing Caller Id Service - Linksys RTP300 - Broadband Router With 2 Phone Ports Administration Manual

8. Contact technical support.
If you are an end user of Linksys VoIP products, contact the reseller or Internet telephony
service provider (ITSP) that supplied the equipment.
If you are an authorized Linksys Voice System partner, contact Linksys technical support.

Managing Caller ID Service

The choice of caller ID (CID) method is dependent on your area/region. To configure CID, use
the following parameters:
Parameter Tab
Caller ID Regional
Method
Caller ID FSK Regional
Standard
The types of Caller ID are as follows:
• On Hook Caller ID Associated with Ringing — This type of Caller ID is used for incoming
calls when the attached phone is on hook. See the following figure (a) – (c). All CID
methods can be applied for this type of CID.
• On Hook Caller ID Not Associated with Ringing — This feature is used to send VMWI
signal to the phone to turn the message waiting light on and off (see Figure 1 (d) and
Linksys ATA Administration Guide
Description and Value
The following choices are available:
• Bellcore (N.Amer,China)—CID, CIDCW, and VMWI. FSK sent after
first ring (same as ETSI FSK sent after first ring) (no polarity reversal or
DTAS).
• DTMF (Finland, Sweden)—CID only. DTMF sent after polarity
reversal (and no DTAS) and before first ring.
• DTMF (Denmark)—CID only. DTMF sentbefore first ring with no
polarity reversal and no DTAS.
• ETSI DTMF—CID only. DTMF sent after DTAS (and no polarity
reversal) and before first ring.
• ETSI DTMF With PR—CID only. DTMF sent after polarity reversal and
DTAS and before first ring.
• ETSI DTMF After Ring—CID only. DTMF sent after first ring (no
polarity reversal or DTAS).
• ETSI FSK—CID, CIDCW, and VMWI. FSK sent after DTAS (but no
polarity reversal) and before first ring. Waits for ACK from CPE after
DTAS for CIDCW.
• ETSI FSK With PR (UK)—CID, CIDCW, and VMWI. FSK is sent after
polarity reversal and DTAS and before first ring. Waits for ACK from
CPE after DTAS for CIDCW. Polarity reversal is applied only if
equipment is on hook.
• DTMF (Denmark) With PR—CID only. DTMF sent after polarity
reversal (and no DTAS) and before first ring.
The default is Bellcore(N.Amer, China).
The ATA device supports bell 202 and v.23 standards for caller ID
generation. Select the FSK standard you want to use, bell 202 or v.23.
The default is bell 202.
This field is not found in the PAP2T.
Configuring Voice Services
Managing Caller ID Service
47