Trunk Status Section (Spa8000); System Page - Linksys RTP300 - Broadband Router With 2 Phone Ports Administration Manual

VoIP Call Decoder Audio decoder being used for the VoIP call leg.
VoIP Call FAX Status of the fax pass-through mode.
VoIP Call Remote Hold Indicates whether the far end has placed the call on hold.
VoIP Call Duration Duration of the call.
VoIP Call Packets Sent Number of packets sent.
VoIP Call Packets Recv Number of packets received.
VoIP Call Bytes Sent Number of bytes sent.
VoIP Call Bytes Recv Number of bytes received.
VoIP Call Decode Number of milliseconds for decoder latency.
Latency
VoIP Call Jitter Number of milliseconds for receiver jitter.
VoIP Call Round Trip Number of milliseconds for delay.
Delay
VoIP Call Packets Lost Number of packets lost.
VoIP Call Packet Error Number of invalid packets received.
VoIP Call Mapped RTP The port mapped for Real Time Protocol traffic for Call 1/2.
Port
Voice tab > Info page >

Trunk Status section (SPA8000)

Field Description
Registration State Indicates if the line has registered with the SIP proxy.
Last Registration At Last date and time the line was registered.
Next Registration In Number of seconds before the next registration renewal.
Message Waiting Indicates whether you have new voice mail waiting. Options are either Yes or
No. This value is updated when voice mail notification is received. You can
also manually modify it to clear or set the flag. Setting this value to Yes can
activate stutter tone and VMWI signal. This parameter is stored in long term
memory and survives after reboot or power cycle.
Mapped SIP Port Port number of the SIP port mapped by NAT.
Voice tab >

System page

You can use the System page to configure your system and network connections. With some
variations, depending on the model, this page includes the following sections:
• "System Configuration section" section on page 100
• "Internet Connection Type section (PAP2T)" section on page 100
• "Optional Network Configuration section (PAP2T)" section on page 100
• "Miscellaneous Settings section (not used with PAP2T)" section on page 101
Linksys ATA Administration Guide
System page
99