To Configure Effect Settings - Casio XW-P1 User Manual

Selecting and Creating Tones

To configure effect settings

1. bm
Hold down EFFECT until the effect list top screen shown below appears.
bm
2.
Next, refer to the list below as you perform operations with the
settings.
■ Effect Settings
Display
Rev Type
Rev Level
Rev Time
Cho Level
Cho Rate
ChoSendRev
Cho/DSP
DSP Select >Ent
(Normal DSP
selection
screen)
Master EQ >Ent
EQ Enable
Low Freq
Low Gain
Mid1 Freq
Mid1 Gain
Mid2 Freq
Mid2 Gain
High Freq
High Gain
E-38
Reverb type. Reverb effect type.
Reverb level. Reverb effect level.
Reverb time. Reverb sustain time.
Chorus level. Chorus effect level.
Chorus rate. Rate of chorus effect undulation.
Chorus send level to reverb. Specifies how reverb is applied to the entire sound to which
the chorus effect is being applied.
Chorus/DSP select. Selects use of either Chorus or Normal DSP ("Chorus and DSP Use
Restrictions", page E-37).
Displays the main Normal DSP selection screen.
• You will not be able to go any further if a Solo Synthesizer tone is selected for Zone Part
1.
You can select from among preset and user tones for the Normal DSP using the same
procedures as those for tone selection.
• For a list of preset Normal DSPs, see the separate Appendix. Selecting "ton" applies the
initial preset DSP of each tone.
• Param A and Param B (page E-88) for the currently selected DSP type appear on the
display. You can adjust these parameters using
7
• Pressing EDIT while this screen is displayed will change to the DSP editing screen
(page E-39).
Master equalizer setting group (item (5) of the "Effect Block Diagram" on page E-37)
Turning this setting off disables the Master EQ setting.
Low frequency band. Adjusts the low frequency band.
Low gain. Adjusts the low gain.
Mid 1 frequency band. Adjusts the mid1 frequency band.
Mid1 gain. Adjusts the mid gain.
Mid 2 frequency band. Adjusts the mid2 frequency band.
Mid2 gain. Adjusts the mid2 gain.
High frequency band. Adjusts the high frequency band.
High gain Adjusts the high gain.
bq
controls to select items and change
Description
3
K1 and K2.
Settings
Type1, Type2
0 to 127
0 to 127
0 to 127
0 to 127
0 to 127
Cho, DSP
ton
Preset: 0-0 to 9-9
User: 0-0 to 9-9
Off, On
200Hz, 400Hz,
800Hz
*
–12 to 0 to +12
1.0kHz to 5.0kHz
*
–12 to 0 to +12
1.0kHz to 5.0kHz
*
–12 to 0 to +12
6.0kHz, 8.0kHz,
10.0kHz
*
–12 to 0 to +12