Table of Contents
Advertisement
In addition to a router, you need a straight-through cable for each computer you want to connect
to the network.
To set up a network using a router:
1
Plug one end of the power adapter into the AC connector on the router and the other end
into a grounded, 110V electrical outlet.
2
Turn on your computers.
3
Plug one end of a straight-through network cable into any numbered port on the router
(except the WAN port). The WAN port is used to connect the router to the DSL or cable
modem and is identified by a label or a switch. Plug the other end of the cable into the
network connector on the computer. As each computer is connected to the router, the
corresponding green indicator should light on the front of the router, indicating a good
connection.
4
Repeat
Step 3
for each computer on the network.
5
For an Internet connection, plug a straight-through cable into the WAN port on the router
and the other end into the Ethernet jack on the DSL or cable modem.
www.gateway.com
Cable/DSL
modem
Router
WAN port
47
Advertisement
Table of Contents
