Installing The Stack Bracket Kit - GE Profile DPVH890EJ Owner's Manual And Installation Instructions

STACKING THE WASHER AND
DRYER (if desired) (cont.)
KIT CONTENTS
❒ Right hand bracket
❒ Left hand bracket
❒ 4 rubber pads
TOOLS YOU WILL NEED
❒ Phillips screwdriver
❒ Open-ended wrench
❒ Pliers
INSTALLATION PREPARATION
Remove the packaging.
Flatten the product carton to use as a pad to lay
the dryer down on its side. Continue using the
carton to protect the finished floor in front of
the installation location.
Installation Instructions
❒ 4 #12 x 1" screws
❒ 4 #8 x 1/2" screws
❒ Gloves
❒ Level
INSTALLING THE STACK
BRACKET KIT
REMOVE THE DRYER LEVELING LEGS
1
A. Carefully lay the dryer on its side. Use the
packing material so you don't scratch the finish
on the dryer.
B. Use an open-end wrench or pliers to remove
the dryer leveling legs.
Back out and remove
all 4 leveling legs
INSTALL RUBBER PADS
2
TO DRYER BASE
Locate the 4 rubber pads in the parts package.
Remove the adhesive backing and firmly place
over on the bracket where you removed the
leveling legs.
40