GE Profile DPVH890EJ Owner's Manual And Installation Instructions page 36

REVERSING THE DOOR SWING (if desired)
REVERSE DOOR HANDLE
3
AND CAPS
A Lay the chrome cover down on a soft,
protected, flat surface so that the inner part
faces upward (resting on the handle side).
Disassemble the door cap from the chrome
cover on the handle side by removing 2 screws
(#8 x 0.625" tapping screws).
B Disassemble the inner handle from the outer
handle by removing 3 screws (#8 x 0.625"
tapping screws). Disassemble the outer handle
from the chrome cover by removing 4 screws
(#8 x 0.625" tapping screws).
Remove
4 x D screws
(outer handle)
Installation Instructions
2 x D
Screws
Door cap
3 x D
Screws
(inner
handle)
Outer
handle
36
REVERSE DOOR HANDLE
3
AND CAPS (CONT.)
C Pop the 2 handle caps out toward you and
reassemble on the opposite side of the chrome
cover, where you removed the outer handle.
Handle caps
D Assemble the outer handle onto the opposite
side of the chrome cover, using 4 screws
(#8 x 0.625" tapping screws).
Outer
handle
Replace
4 x D
screws
(outer
handle)