Installing The Stack Bracket Kit - GE GFDS150GDWW Owner's Manual

INSTALLING THE STACK BRACKET KIT

1. Remove the Dryer
A. Carefully lay the dryer on its side.
B. Use an open-end wrench or pliers
Back out and remove
all 4 leveling legs
2. Install Rubber Pads
Locate the 4 rubber pads in the parts
package. Remove the adhesive backing
and firmly place over on the bracket
where you removed the leveling legs.
3. Install Bracket
A. Align the holes in the left bracket
B. Repeat the above step with the right
Leveling Legs
Use the packing material so you
don't scratch the finish on the dryer.
to remove the dryer leveling legs.
to Dryer Base
to Dryer
with the holes in the bottom left
corner of the dryer. Use a Phillips
screwdriver to install the 2 #12 x 1
tapping screws.
bracket on the bottom right corner
of the dryer.
GEAppliances.com
C. Set the dryer upright.
NOTE: Make sure to set the dryer
on a piece of packing material so
the brackets that are attached to
the bottom of the dryer do not damage
the floor.
21