Fujitsu ScanSnap S510 Operator's Manual page 243

Symptom
Paper is not fed (stops
midway).
The scanner is not
recognized even if
ScanSnap Manager is
installed.
The file size of a
scanned black & white
image is the same as
that of a scanned color
document image.
Images on the back of
pages, which are
printed-through, are
overlaid on the scanned
image when scanning a
two-sided document.
(This is called "noise" of
the back side image.)
Check This Item
Is the Pick roller dirty?
Is the Pick roller worn out?
Are there any debris on the
document feeding path?
Do the loaded documents
satisfy the conditions
described in section "3.2
Paper Size of Documents
to be Scanned" (page 46)?
If not, they might not pass
smoothly through the ADF.
Did you connect the
scanner to your PC before
installing ScanSnap
Manager?
Is the scanner registered
as "Other device" in the
"Device Manager"?
Is the B&W document
scanned in the color
mode?
Is the "Setting for text only
document" checkbox
cleared in the "Read mode
option" dialog box ([Option]
on the [Scanning] tab of
the "ScanSnap Manager -
Scan and Save Settings"
dialog box)?
ScanSnap S510 Operator's Guide
7.2 Troubleshooting Checklist
Resolution
Clean the Pick roller by following the
instructions in "8.3 Cleaning the
Inside of the Scanner" (page 232).
Replace the Pick roller by following
the instructions in "9.3 Replacing the
Pick Roller" (page 243).
Remove any debris from the
document feeding path. (Refer to
"7.1 Clearing Document Jams"
(page 218).
Try the following:
•
Slightly push through with your
finger the first sheet of the
documents at the start of
scanning.
•
Change the insertion direction of
the document.
On the [Start] menu, select [Control
panel] [System] [Hardware]
[Device Manager].
Delete the device name such as USB
device (differs with the OS) under
"Other Device" selection in the
[Device Manager] and restart your
PC.
Select "B&W" from the [Color mode]
drop-down list on the [Scanning] tab
in the "ScanSnap Manager - Scan
and Save Settings" dialog box.
Mark the "Setting for text only
document" checkbox. (Available only
in color mode) Marking it makes
characters, lines, and contrasts
sharper and clearer, and removes
the noise of the back side image.
Note that you can also use this
mode for documents including
photos and illustrations. Even if this
mode is used, the contrasts and
colors might be affected.
7
223