Programmed Edit Recording; To Change The Program Of Each Side; To Clear The Edit Program - Aiwa CX-NA303 Operating Instructions Manual

In the programmed edit recording function the tracks can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
m
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
1
2
3
4
5
Insert the tape into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press CD and
load the disc(s).
Press EDIT/CHECK twice while pressing SHIFT
on the remote control.
"EDIT" and "PRGM" are displayed.
c When "Al" is displayed, press
EDIT/CHECK
while pressing
SHIFT
again.
Press numbered buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified.
The -, > or MULTI JOG are also available to designate
the tape length.
Tape length
Tape side A (front side)
Maximum recording
time for side A
Press DISC DIRECT PLAY 1-3 to select a disc.
Then, press numbered buttons O-9 and + 10 on
the remote control to program a track.
Example: To select the 10th track of disc 2, press
DISC
DIRECT PLAY 2,
then press
+10
and O.
Remaining time Programmed
on side A
tracks
L
6
7
8
9
Repeat step 5 for the rest of the tracks for side! ~
A.
ill
,3 ~
,~::miij
A track whose playing time is longer than the remaining time ~~; ~
cannot be programmed.
8
,>,,:
~,. ,
., ':;/
::S":
Press EDIT/CHECK while pressing SHIFT on the! ,#
remote control to select side B and program the
tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B, (reverse side)
Press EDIT/CHECK while pressing SHIFT
select side A and press REC/REC MUTE
start recording.
to
to
CD play and recording of edited tracks for the first side start
simultaneously. When the last track programmed for side A
is finished, deck 2 enters the recording stop mode. After
entering the recording stop mode, go to step 9.
Press EDIT/CHECK while pressing SHIFT on tht?
remote control for recording of the second side.
B is displayed.
10 Turn over the tape in deck 2 and press REC/
REC MUTE to start recording.
Recording starts.
To stop recording
Press , Recording and CD play stop simultaneously.
To
check the order of the programmed track numbers
Before recording, press
EDIT/CHECK
while pressing
SHIFT
on
the remote control to select side A or B, and press - or N>
repeatedly.
Disc number Tape side Program number
Track number Programmed track
numbers
To change the program of each side
Press EDIT/CHECK while pressing SHIFT on the remote control
to select side A or B, and press 9 CLEAR to clear the program
on the selected side. Then program tracks again.
To clear the edit program
Press
CLEAR
twice so that "EDIT" disappears on the dlispla.y.
ENGLISH 14