Config Radius; Show Radius; To Configure Radius Settings - D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual

config radius

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To configure RADIUS settings:

DES-3026:4#config radius 1 10.48.74.121 key dlink default
Command: config radius 1 10.48.74.121 key dlink default
Success.
DES-3026:4#

show radius

Purpose
Syntax
Description
Parameters
Restrictions
DES-3026:4#config radius delete 1
Command: config radius delete 1
Success.
DES-3026:4#
Used to configure the Switch's RADIUS settings.
config radius <server_index 1-3> {ipaddress <server_ip> | key
<passwd 32> | auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}
The config radius command is used to configure the Switch's RADIUS
settings.
<server_index 1-3> − Assigns a number to the current set of RADIUS
server settings. Up to 3 groups of RADIUS server settings can be entered
on the Switch.
<server_ip> − The IP address of the RADIUS server.
key − Specifies that a password and encryption key will be used between
the Switch and the RADIUS server.
<passwd 32> − The shared-secret key used by the RADIUS server
and the Switch. Up to 32 characters can be used.
default − Returns all of the ports in the range to their default RADIUS
settings.
auth_port <udp_port_number 1-65535> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535> − The UDP port number for
accounting requests. The default is 1813.
Only administrator-level users can issue this command.
Used to display the current RADIUS configurations on the Switch.
show radius
The show radius command is used to display the current RADIUS
configurations on the Switch.
None.
None.
118