Table of Contents
Advertisement
Configuring with the Command-Line Interface
This chapter describes how to use the Cisco IOS software command-line interface (CLI) to configure
basic Cisco VG224 functionality.
This chapter presents the following major topics:
Configuring the Host Name and Password, page 3-2
•
Configuring Fast Ethernet Interfaces, page 3-4
•
Saving Configuration Changes, page 3-5
•
•
Where to Go Next, page 3-5
Follow the procedures in this chapter to configure the Cisco VG224 manually or, if you want to, change
the configuration after you have run the setup command facility (see
section on page
This chapter does not describe every configuration possible—only a small portion of the most commonly
used configuration procedures. For advanced configuration topics, refer to the Cisco IOS configuration
guide and command reference publications. See
If you skipped the previous chapter,
Note
configured a Cisco VG224, go back to that chapter and read it now. The chapter contains important
information you need to configure your Cisco VG224 successfully.
OL-5005-01
2-2).
Chapter 2, "Using the setup Command,"
C H A P T E R
"Using the setup Command"
"Obtaining Documentation" section on page
Cisco VG224 Voice Gateway Software Configuration Guide
3
x.
and you have never
3-1
Advertisement
Table of Contents
