Configuring Controller And Interface Parameters; Configuring Fast Ethernet And Serial Interface Parameters - Cisco SLM224G4PS Software Manual

Voice gateway
Hide thumbs Also See for SLM224G4PS:
Table of Contents

Advertisement

Chapter 2
Using the setup Command
Configure LAT? [no]:
Configure IP? [yes]:
Note
Configure bridging? [no]:
(Optional) Configure CHAP:
Step 9
All users dialing in through the PRI will need to be
authenticated using CHAP. The username and password are
case sensitive.
Do you want to enter username and passwords for PPP authentication ? [no]:
Step 10
Configure the ISDN switch type for PRI.
The following ISDN switch types are available:
Choose ISDN PRI Switch Type [2]:
Note

Configuring Controller and Interface Parameters

From this point on in the setup process, the prompts you see vary depending on the interface cards
installed in your Cisco VG224. The following sections provide examples of the setup steps for card.
Refer to the sections appropriate to your Cisco VG224.
Configuration examples include the following:
When you complete the setup steps for your interface modules, go to
page 2-6

Configuring Fast Ethernet and Serial Interface Parameters

This section illustrates the following:
OL-5005-01
Community string [public]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 1
If you answer no to IGRP, you are prompted to configure RIP.
[0] none............If you do not want to configure ISDN
[1] primary-4ess....AT&T 4ESS switch type for US and Canada
[2] primary-5ess....AT&T 5ESS switch type for US and Canada
[3] primary-dms100..Northern Telecom switch type for US and Canada
[4] primary-net5....European switch type for NET5
[5] primary-ni......National ISDN Switch type for the U.S
[6] primary-ntt.....Japan switch type
[7] primary-qsig....QSIG switch type
[8] primary-ts014...Australian switch type
BRI is not currently supported.
Configuring Fast Ethernet and Serial Interface Parameters, page 2-5
Configuring Fast Ethernet and Serial Interface Parameters, page 2-5
for directions on saving your configuration.
Configuring Controller and Interface Parameters
Completing the Configuration,
Cisco VG224 Voice Gateway Software Configuration Guide
2-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vg224

Table of Contents