Encore ENDSL-A2+WIGX2 User Manual page 9

With Dynamic DNS support, you can have a static hostname alias for a dynamic IP
address, allowing the host to be more easily accessible from various locations on the Internet.
You must register for this service with a Dynamic DNS client.
DHCP Support
DHCP (Dynamic Host Configuration Protocol) allows individual clients to obtain TCP/IP
configuration at start-up from a centralized DHCP server. The ADSL router has built-in DHCP
server capability enabled by default. It can assign IP addresses, an IP default gateway and DNS
servers to DHCP clients. It can also act as a surrogate DHCP server (DHCP Relay) where it
relays IP address assignment from the actual real DHCP server to the clients.
Device Management
Web-based GUI Configuration / Management
Command-line Interpreter (CLI)
SNMP support (V.1 and V.2C)
Telnet Remote Management
Firmware upgrade via FTP / TFTP (Web-based GUI)
Built-in Diagnostic tool and IP Ping
TR-069 support (CPE WAN Management Protocol) (Optional)
10/100M Auto-negotiation Fast Ethernet switch
This auto-negotiation feature allows the router to detect the speed of incoming
transmissions and adjust appropriately without manual intervention. It allows data transfer of
either 10 Mbps or 100 Mbps in either half-duplex or full-duplex mode depending on your Ethernet
network.
Bridging / Routing support
Ethernet to ADSL self-learning Transparent Bridging (IEEE 802.1D)
IP routing-RIPv2 (backward compatible with RIPv1)
Static IP routing
Routing (TCP/IP/UDP/ARP/ICMP)
IP Multicast IGMP v1/v2
Wireless
IEEE802.11g compliance, backward compatible with 802.11b (at 11Mbps)
64/128-bit WEP, WPA, WPA2 security
Dynamic date rate scaling at 54, 48, 36, 24, 18, 12, 9 and 6Mbps for IEEE802.11g
8