Encore ENDSL-A2+R2 User Manual page 62

leaving your system is considered Incoming and data entering your system is Outgoing.
IP/MAC Filter rule Index: The IP/MAC Filter rule Index from 1 to 6.
IP/MAC Filter Rule Editing: Select the IP/MAC Filter Rule Index you wish to modify.
Active: Toggle this rule index on or off with Yes or No, respectively.
Source IP Address: Enter the source IP address you wish to deny access to your system.
Subnet Mask: Enter the subnet mask of the source IP address.
Port Number: Enter the port number of the source IP address. Note that 0 means all that ports
are allowed.
Destination IP Address: Enter the destination IP address that you wish to deny access to
your system.
Subnet Mask: Enter the subnet mask of the destination IP address
Port Number: Enter the port number of the destination IP address. Note that 0 means that all
ports are allowed
Protocol: Select the protocol to filter. Choices are TCP, UDP, and ICMP.
Rule Unmatched: Choices are Forward and Next. Select what happens to the data in
question if the rule you are currently editing is unmatched. Next means that the data is then
compared to the next IP filter rule. Forward means that the data will be allowed into your
system. Note that a Forward rule should be the last rule, as no data will be compared to rules
after a Forward rule.
IP/MAC Filter Set Index: Select the IP/MAC filter set you wish to view.
For Example
61