Encore ENDSL-A2+R2 User Manual page 47

[PPPoA/PPPoE]
Select this option if your ISP requires you to use a PPPoE connection. This option is typically
used for DSL service. Select Dynamic PPPoE to obtain an IP address automatically for your
PPPoE connection. Selection Static PPPoE to use static IP address for your PPPoE
connection. Please enter the information accordingly.
Username: Enter your username for your PPPoE/PPPoA connection.
Password: Enter your password for your PPPoE/PPPoA connection
Encapsulation: For both PPPoE/PPPoA connections, you need to specify the type of
Multiplexing, either LLC or VC mux.
Connection Setting: For PPPoE/PPPoA connection, you can select Always on or Connect
on-demand. Connect on demand is dependent on the traffic. If there is no traffic (or Idle) for a
pre-specified period of time, the connection will tear down automatically. And once there is
traffic send or receive, the connection will be automatically on.
IP Address: For PPPoE/PPPoA connection, you need to specify the public IP address for this
ADSL Router. The IP address can be either dynamically (via DHCP) or given IP address
provide by your ISP. For Static IP, you need to specify the IP address, Subnet Mask and
Gateway IP address.
Bridge Mode: The modem can be configured to act as a bridging device between your LAN
and your ISP. Bridges are devices that enable 2 or more networks to communicate as if they
are 2 segments of the same physical LAN. Please set the Connection type.
46