Roland Edirol R-44 Owner's Manual page 16

Introducing the R-44
Side panel (right)
fig.panel-4.eps
Combo input jacks 1–4
These analog audio input connectors are compatible with mic preamps. They support either XLR or
standard plugs, which can selected to match the connected device. They also accept either balanced or
unbalanced connections.
You can use Combo input jacks 1–4 as four channels of monaural input or as two stereo pairs, 1/2 and 3/
4. For details, refer to "1 Recording Setup" (p. 66).
* The XLR type supports 48 V phantom power and allows you to connect phantom-powered condenser mics. In this
case, turn on the Phantom power switch
fig.XLR-TRS
922 The R-44 is equipped with balanced (XLR/TRS)
type connectors. The wiring diagrams for these
connectors are shown in the figure. Connect
them after first checking the wiring diagrams of
the device you intend to connect.
* If you use connection cables with resistors are used, the volume level of devices connected to the inputs (Combo
input jacks 1–4) may be low. If this happens, use connection cables that do not contain resistors.
16
on the top panel.
3
1:GND
2:HOT
HOT(TIP)
3:COLD
GND(SLEEVE)
COLD(RING)