The Echonav Mode And Selection Menus - EchoStar DVR-5000 HDD Viaccess Supplementary Manual

Familiarization
Section 4
2.2.7. FACTORY RESET - SUB-MENU
This sub-menu allows you to reset the receiver to the initial factory settings. The Memory -
User settings option restores the factory settings over your personal settings. All personal
settings like parental control and favorites will be replaced with the factory default settings.
3.

THE ECHONAV MODE AND SELECTION MENUS

3.1. GROUP AND SORT
Once in a list, the selection for Group (yellow key) and Sort (blue key) are kept until you
change the selection. The selection is made visible in the InfoBanner with icons
NOTE
Sometimes a list seems to be empty because of the settings of the Group and Sort
option. If this happens, select Group - None and Sort - None.
3.2. EDIT
When in the edit menu, the Move, Lock and Delete option gives only access to the related
function.
3.2.1. MOVE
When in the edit menu, you can select the move option only with Group and Sort set to none.
You can move the selected channel manually or by number. After the move action you can
press the recall key to go to the location where you started the move action.
Page 4 - 10
Memory - User settings
I
To instruct the receiver to delete all personal
settings and restore the factory default settings.
Hard disk - Recordings
I
To instruct the receiver to delete (only) all TV and
Radio recordings from the hard disk.
Hard disk - MP3 Songs (DVR-7000 series only)
I
To instruct the receiver to delete (only) all
MP3 songs from the hard disk.
Hard disk - Backgrounds
I
To instruct the receiver to delete (only) all the
personal backgrounds from the hard disk.
Hard disk - EPG Data
I
To instruct the receiver to delete (only) all
scheduled EPG data from the hard disk.
Hard disk - Photos (DVR-7000 series only)
I
To instruct the receiver to delete (only) all photos
from the hard disk.
Confirm
I
With this field you can confirm the selection made
and execute the selected procedure. After the
erase procedure is finished, you are taken to the
initial setup procedure. (for detailed instructions,
please refer to section Installation).
White;
I
To select the Move option.
Red bullet;
I
To indicate that the selection is active.
Numerical field;
I
To enter the channel number where you want to
move to.
On the RCU, the
I
To return to the previous location in the list.
key;
EchoNAV 2.2