Connect To The Console Port; Connect To The Console Port With Microsoft Windows - Cisco Firepower 1010 Hardware Installation Manual

Connect to the Console Port

•
•
•

Connect to the Console Port with Microsoft Windows

You must install a USB device driver the first time a Microsoft Windows-based PC is connected to the USB
console port on the chassis, otherwise the connection fails.
To uninstall the driver, use the Add Remove Programs utility or the Setup-exe program.
Note Disconnect the console terminal before uninstalling the driver.
Step 1 Obtain the appropriate driver (Cisco_usbconsole_driver_X_X_zip, where X is a revision number) for your model from
the Cisco Download Software
Step 2 Install the driver.
Step 3
Connect a 5-pin USB Mini B to the console port as shown in the following figure.
Connect to the Console Port with Microsoft Windows, on page 33
Connect to the Console Port with Mac OS X, on page 35
Connect to the Console Port with Linux, on page 35
site, USB Console Software category.
4
C H A P T E R
Cisco Firepower 1010 Hardware Installation Guide
33