Table of Contents
Advertisement
iii Slide out the blade or blanking blade.
2
Open both retaining latches on the front of the MCU MSE 8510. When open, a
retaining latch is at a 90
3
Slide the MCU MSE 8510 into the blade slot (as shown in Figure 2) until it
stops.
4
Simultaneously close both retaining latches on the blade (thereby engaging the
connectors at the rear of the blade) to secure in the chassis as shown in Figure 3.
5
Using a No.1 Phillips screwdriver, tighten the screws in the retaining latches
with a clockwise quarter turn.The power is connected automatically as soon as
you close the latches. The LCD panel displays messages as parts are checked and
eventually you see "Waiting for application to boot" after which the Cisco logo
appears followed by the IP address allocated to the MCU MSE 8510.
Figure 2: Inserting a blade into the chassis
angle perpendicular to the front of the blade.
°
Installing the MCU MSE 8510
6
Advertisement
Table of Contents
