Low Battery Warning - Dish Network 322 User Manual

Dish 322: user guide
Hide thumbs Also See for 322:
Table of Contents

Advertisement

Chapter 2
Receiver Description and Installation
Batteries
Attach a UHF Antenna
Page 18
The remote controls come with AAA batteries, which need to be installed
when you first receive your system. When you replace old batteries, you
should replace all of the batteries. Use batteries of the same kind, for
example alkaline or carbon zinc, and don't mix batteries of different kinds.
Alkaline batteries last longer than carbon zinc.
Installing or Changing the Batteries
1. Press down on the battery cover's top latch and slide the
cover off.
2. If you are changing out batteries, take out all of the old
batteries.
3. Put the new batteries in. Make sure you match the plus
("+") ends with the plus markings on the battery case.
4. Slide the cover back into place.

Low Battery Warning

When you see a low battery warning message below the
the batteries in your remote control are weak and need to be replaced.
You need to attach the UHF remote antenna to the
receiver's back panel
R
EMOTE
you can use UHF Pro Remote Control 2.
: Be sure to set the antenna straight up so you can use the remote
Note
control from as far away as possible. Don't let the antenna touch anything.
input so
A
NTENNA
,
Program Banner

Advertisement

Table of Contents
loading

This manual is also suitable for:

Network satellite receiver

Table of Contents