Connecting A Record Player; Connecting A Cd Player - Denon AVR-3311CI Owner's Manual

Connecting an antenna
n AM loop antenna assembly
1
Put the stand section
through the bottom of the
loop antenna from the
rear and bend it forward.
Loop
antenna
2
Insert the projecting part
into the square hole in
the stand.
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
Standing alone
Use the procedure shown left to assemble.
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM
loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
• If the signal has noise interference, connect the ground terminal
(GND) to reduce noise.
• If you are unable to receive a good broadcast signal, we recommend
installing an outdoor antenna. For details, inquire at the retail store
where you purchased the unit.

Connecting a record player

You can enjoy playing records.
Stand Cables used for connections
Square
Audio cable (sold separately)
hole
Projecting (White)
Audio cable
part
Turntable
(MM cartridge)
AUDIO
OUT
L R
Nail, tack, etc.
• This unit is compatible with record players with an MM cartridge.
When you connect to a record player with an MC cartridge, use a
commercially available MC head amp or a step-up transformer.
• When you increase the volume without connecting the record
player, there may be "booming" noise from the speakers.
NOTE
The SIGNAL GND terminal of this unit is not a safety ground
connection. Connect it to reduce noise when noise is excessive.
Note that depending on the record player, connecting the ground line
may have the reverse effect of increasing noise. In this case, it is not
necessary to connect the ground line.
L L
(Red)
R R
GND

Connecting a CD player

• You can enjoy CD sound.
• Select the connector to use and connect the device.
Cables used for connections
Audio cable (sold separately)
(White) L
Audio cable
(Red)
R
CD player
AUDIO
AUDIO
OUT
L R
L R
L R
in Set as Necessary
Set this to change the digital input connector to which the input
source is assigned.
"Input Assign" (vpage 69)
ENGLISH
L
R
21