Installing The Server Module Control Panel - Dell 1955 Hardware Owner's Manual

Figure 3-25. Removing and Installing the Server Module Control Panel Assembly
1
7
6
1 screws (2)
4 server module-board
connector
7 control panel

Installing the Server Module Control Panel

1 Place the new control panel under the server module top bracket and secure it with the two screws. See
Figure 3-25.
2 Route the control-panel cable under its retaining clip.
3 Connect the control-panel cable to the server module-board connector:
Pull up the retaining clip on top of the connector.
a
Slip the cable between the retaining clip and the connector and press down on the clip to secure
b
the cable.
NOTE:
The cable attaches to the connector on the control panel in the same manner.
4 Close the server module. See "Closing the Server Module" on page 76.
5 Install the server module. See "Installing a Server Module" on page 74.
5
4
2 control panel cable retaining
clip
5 control panel cable
3
3 retaining clip
6 top bracket
Installing System Options
2
97