Stylus; Removing The Stylus; Replacing The Stylus; Handle - Dell Latitude E6400 XFR Service Manual

1. Replace the modem (see Replacing the Modem).
2. Replace the system board (see Replacing the System Board Assembly).
3. Follow the procedures in After Working on Your Computer.

35 Stylus

35.1 Removing the Stylus

1. Follow the procedures in Before Working on Your Computer.
2. Remove the stylus from the stylus bay of the handle.
3. Close the display and turn the computer upside down.
4. Run the stylus and tether through the tether loop, slide the lanyard from the loop then remove from unit.

35.2 Replacing the Stylus

1. Pinch the end of the tether loop to a point.
2. Place the tether loop, pointed end first, through the tether anchor at the edge of the system.
3. Run the stylus and tether through the tether loop.
4. Once the stylus and tether are completely through the tether loop, pull the stylus to secure the tether loop
onto the tether anchor.
5. Insert stylus in stylus bay of the handle
6. Follow the procedures in After Working on Your Computer.

36 Handle

Page 64
™
Dell Latitude™ E6400 XFR Service Manual
1
1 Tether anchor point