D-Link Xtreme N Duo DAP-1522 User Manual page 34

Section  - Configuration
Priority by
Users can set the priority and percentage of total bandwidth
Protocol:
reserved for each of their four traffic categories. Please
note that the combined percentage value of transmission
limits does not have to be 100%. These percentages
represent the maximum bandwidth designated for each
traffic category.
Wireless to
The value entered here indicates the wireless to Ethernet
Ethernet:
speed required before the Advanced QoS function is
enabled. Advanced QoS will be enabled once the total
bandwidth reaches or surpasses the set value. The
suggested range is 800 ~ 96000kbits/sec.
Ethernet to
The value entered here indicates the Ethernet to wireless
Wireless:
speed required before the Advanced QoS function is
enabled. Advanced QoS will be enabled once the total
bandwidth reaches or surpasses the set value. The
suggested range is 800 ~ 96000kbits/sec.
ACK/DHCP/ICMP/
Represents the priority value and bandwidth limit applied to ACK, DHCP, ICMP, and DNS for packet delivering.
DNS Priority:
Web Traffic
Traffic generated by typical Web services (packets sent through ports 80,443, 3128 and 8080).
Priority:
Mail Traffic
Traffic generated by e-mail sending and receiving (ports 25, 110, 465 and 995).
Priority:
Ftp Traffic Priority:
Traffic generated by FTP Uploading and Downloading (ports 20, 21).
Other Traffic
Other traffic generated that does not regard the aforementioned packet delivery.
Priority:
Note: Normally the wireless connection transmits application data packets based on the wireless to Ethernet speed and Ethernet to wireless speed.
Users can treat the two speeds as system transmission bandwidth, where all applications will share the whole system bandwidth based on assigned
priorities. Note that the maximum amount of bandwidth that can be used is the same as the set value of both speeds.
D-Link DAP-15 User Manual