Canon Laser Shot LBP3300 User Manual page 386

Cause 6 The hardware of the network board is in an abnormal condition.
Remedy Report the problems to your local authorized Canon dealer.
The ERR indicator on the network board is on.
Cause The network cable is disconnected or broken, or the network board is not
installed properly.
Remedy 1 Make sure the network cable is connected properly.
Remedy 2 Replace the network cable with a proper one and check if there is no
disconnection or damage.
Remedy 3 If the ERR indicator still comes on even after applying the Remedy 1 and 2,
contact your local authorized Canon dealer for servicing.
The ERR indicator on the network board blinks at an interval of four times.
Cause The DIP switch 1 on the network board is ON.
Remedy Set the DIP switch 1 to OFF once.
The ERR indicator on the network board keeps blinking.
Cause The hardware of the network board is in an abnormal condition.
Remedy Contact your local authorized Canon dealer for servicing.
Problems on Installing the Network Board
7
7-47