Connecting The Lan Cable; Tcp/Ip Network Settings (Windows, Macintosh, Unix) - Canon imagePROGRAF W6400 User Manual

TCP/IP Network Settings (Windows, Macintosh, UNIX)

TCP/IP Network Settings (Windows, Macintosh, UNIX)
This chapter describes the setting methods and procedures
for connecting the printer to a TCP/IP network.
Procedures Required for a TCP/IP Net-
work
Here is a summary of the procedures required to set the
printer for use on a TCP/IP network.
The following procedure should be performed by the
network system administrator.
1 Installing the network interface board
First, install the optional network interface board
2

Connecting the LAN Cable

Connect the LAN port to the HUB with the LAN cable.
3 Setting the Printer IP Address
Set an IP address that will allow the printer to
communicate with the computer that you want to use.
Use either of the utilities below to perform this setting.
• GARO Device Setup Utility (Canon software
application provided with the printer.)
• ARP/PING Command
• Printer operation panel
5- 5
4 Install the Printer Driver
Install the Canon imagePROGRAF printer driver for
either Windows or Macintosh (OS X). Follow the
procedure on the Quick Start Guide to install the
printer driver. There is no printer driver for UNIX.
Performing the TCP/IP Protocol
5
Settings
Performing the TCP/IP protocol settings according to
you needs as required. You can use the Web Browser
to perform these settings from your computer.
→ Quick Start
Connecting the LAN Cable
Guide
1
→
P.5-5 Use a LAN cable to connect the printer LAN
port to the HUB port.
→
P.5-7
a
TOP
Chapter 1
Basic Procedures
→ Quick Start
Guide
Chapter 2
Using a Variety of
Media
Chapter 3
→
P.5-15
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index