Manual Tuning - Aiwa XR-M35 Operating Instructions Manual

MANUAL TUNING
1
2
BANDI
1
MODE
TUNER
2
SHIFT
Press the TUNER/BAND button repeatedly to
select the desired band.
n
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
When using the remote control, press the BAND/MODE
TUNER button repeatedly while power is on.
Press the ++ or ~ button to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, TUNE is displayed for a moment.
During FM stereo reception, [[[01] is displayed.
When an FM stereo broadcast contains noise
Press the BAND/MODE TUNER button while pressing the SHIFT
button on the remote control.
"MONO" appears on the display.
Noise is reduced, although reception is monaural.
MONO
To restore stereo reception, repeat the above again.
To
change the
AM
tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
While pressing the TUNER/BAND button, press the POWER
button.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations (see
"PRESETTING STATIONS") are cleared.
The preset stations
have to be set again.
To search for a station quickly (Auto Search)
Keep the + or - button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
To stop the Auto Search manually, press the+ or - button.
The Auto Search may not stop at stations with very weak
signals.
7
ENGLISH