132
FX PARAMETERS
FX Parameters
This section describes all types and parameters of the effects included in the DPS24's internal effects.
The FX page shows a graphic representation of the currently selected effect, and the parameters for
that effect can be edited using the Q-Link knobs Q1-Q6.
If there are more than six parameters for the selected effect, the [F5] softkey provides access
to a second set of parameters for that effect:
REVERB
Although the parameter values of the following reverb types are different, the available pa-
rameters are common to all reverb types (except Non-Linear and Reverse reverb).
• Pre-D
(1ms - 100ms)
• Time
(0.1sec - 10sec) Adjusts the Time of attenuation of reverberation.
• Diff
(0% - 100%)
• HFDamp (20Hz - 20kHz) Frequency at which the higher range of reverberation is cut.
• Width
(0% - 100%)
• Near
(0% - 100%)
User Guide
Adjusts the Pre-Delay time of early reflections.
Adjusts the Diffusion (density) of reverberation.
Adjusts the width and spread of the stereo image.
Adjusts the imaginary distance to the sound source.
The lower the value, the more depth and distance.