When 5.1 is selected as the Pan Mode, an additional parameter is available on [Q2] for the
LFE Filter setup. The possible settings are: LFE Filter;
• ON:
a 120Hz Low Pass Filter is always applied to the LFE Bus.
• OFF: the Low Pass filter is not applied to the LFE Bus, except in Stereo or Mono
fold-down (or Downmix ) mode (when the NEAR or MONO key is enabled), as explained
further in this manual.
• FORCE OFF: the Low Pass filter is never applied to the LFE output.
A look back at the PROJECT page will reveal that the mixer mode is also reflected there for
easy identification of surround and stereo mixes when you're selecting which project to load.
NOTE: The mixer mode information is only shown in the PROJECT page if the Show Project Info prefer-
ence is enabled. If you don't see this information on the screen, go to the SETUP page and enable it.
Once you have created a surround project the DPS24 will switch to Surround mode in the
selected format whenever you load that project.
If you subsequently load a stereo project it will switch back to Stereo mode.
CREATING A SURROUND PROJECT
213
User Guide