The Display Button
Making
Management
Connections
Connecting to a
10BASE-T Ethernet
Port
The front panel of the Management Module includes a display button
that is located next to the LED display, and labeled
shows status information when you power on the Management Module,
and shows
when the Management Module is running normally.
Pri
When the Management Module is running normally, the following
information appears in the LED display when you press the display
button:
The first time that you press the display button, the LED display shows
(Front Panel Ethernet Interface).
FPEI
The second time that you press the display button, the LED display
shows
(Version) and then, after a few seconds, the release of
Vers
software that is running the Management Module. Example:
This section describes the connections that you can make to
communicate with the Management Module. Choose the connection
that is most appropriate to your installation. After you have connected to
the Management Module, you can configure its characteristics.
Connect the Management Module to a 10 Mbps (Megabits-per-second)
Ethernet network or device using the front panel 10BASE-T Media
Dependent Interface (MDI) port. The Management Module uses an RJ-45
connector for the 10BASE-T port.
Table 6 lists the 10BASE-T MDI port pinouts.
Table 6 10BASE-T (MDI) Port Pinouts
Pin
1
2
3
4
5
6
7
8
Making Management Connections
Signal Name
Transmit Data plus (TD+)
Transmit Data minus (TD-)
Receive Data plus (RD+)
no connection
no connection
Receive Data minus (RD-)
no connection
no connection
63
. The LED display
DSPLY
.
0300