Loading Batteries; Inserting An Sd Card - Bushnell 11 0834 Instruction Manual

Loading Batteries

Turn the ImageView over, and slide open the battery cover as indicated by the arrow,
then tilt it up on its hinges. Insert 2 AAA Alkaline or Lithium batteries into the
compartment in the direction indicated by the diagrams inside, then tilt the cover
down again and slide it back into place until it clicks. Note: Rechargeable NiMh type
batteries may also be used, but some may not deliver adequate current to power the
ImageView. AAA NiMh batteries with a current rating of 850 mAh or higher are
recommended.

Inserting An SD Card

The camera can store from about 15 (at 2272x1760 resolution and best quality) up to well over 300 photos in
the 16 MB internal memory, depending on resolution and quality settings (refer to the chart at the back of this
manual). To expand the available storage, you may add an optional SD (Secure Digital) memory card, with 1GB or
smaller capacity (256MB, 512MB etc). MMC cards, which look similar to SD cards, are not recommended. The
card is inserted into the slot on the back of the camera pod, with the "notched" corner on the left as indicated by
the card icon below the slot. Insert the SD card with the label side facing down. Note: be sure the power is turned off
before inserting or removing cards to prevent possible loss of files or damage to the card. A new card will not require
formatting, but a card that has been previously used in other devices (cameras, PDAs, etc) should be formatted by
the ImageView before beginning to take photos or videos (see the "Review Menu" section for how to do this). Note
that formatting will erase all files previously stored on the card, so be sure they have been downloaded or
copied first if you wish to keep them.
8
Imageview 110833+110834 1LIM fin8 8
Tripod
Socket
Battery
Compartment
(Slide Open
In Direction
of Arrow)
3/5/07 1:58:35 PM