D-Link DES-3018 User Manual page 61

DES-3010F/DES-3010FL/DES-3010G/DES-3016/DES-3018/DES-3026 Fast Ethernet Switch Manual
Group Name
SNMP Version
Auth-Protocol
Priv-Protocol
To return to the SNMP User Table, click the
To add a new entry to the SNMP User Table Configuration, click on the Add button on the SNMP User
Table page. This will open the SNMP User Table Configuration page, as shown below.
The following parameters can set:
Parameter
User Name
Group Name
SNMP Encryption
Auth-Protocol
Priv-Protocol
This name is used to specify the SNMP group created can request SNMP messages.
V1 - Indicates that SNMP version 1 is in use.
V2 - Indicates that SNMP version 2 is in use.
V3 - Indicates that SNMP version 3 is in use.
None - Indicates that no authorization protocol is in use.
MD5 - Indicates that the HMAC-MD5-96 authentication level will be used.
SHA - Indicates that the HMAC-SHA authentication protocol will be used.
None - Indicates that no authorization protocol is in use.
DES - Indicates that DES 56-bit encryption is in use based on the CBC-DES (DES-56)
standard.
Figure 6- 23. SNMP User Table Configuration window
Description
Enter an alphanumeric string of up to 32 characters. This is used to identify the SNMP user.
This name is used to specify the SNMP group created can request SNMP messages.
Click the encrypted check box to enable encryption for the SNMP protocol. This feature is
for users utilizing the SNMP V3 version. The user may configure the encryption in the
following two fields.
MD5 - Specifies that the HMAC-MD5-96 authentication level will be used. This field is only
operable when V3 is selected in the SNMP Version field and the Encryption field has been
checked. This field will require the user to enter a password.
SHA - Specifies that the HMAC-SHA authentication protocol will be used. This field is only
operable when V3 is selected in the SNMP Version field and the Encryption field has been
checked. This field will require the user to enter a password.
None - Specifies that no authorization protocol is in use.
DES - Specifies that DES 56-bit encryption is in use, based on the CBC-DES (DES-56)
standard. This field is only operable when V3 is selected in the SNMP Version field and the
Encryption field has been checked. This field will require the user to enter a password
between 8 and 16 alphanumeric characters.
Show All SNMP User Table Entries
48
link.