Aiwa NSX-V70 Operating Instructions Manual page 12

POWER I
I $
._— _ —.. —. ——— ——.. —< .
R6(AA)
BEFORE OPERATION
To
turn the unit on
Press one of the function buttons (TAPE, TUNER, VIDEO/AUX,
CD).
Playback of the inserted disc or tape begins, or the previously
tuned station is received (Direct Play Function).
The POWER button is also available.
The disc compartment may open and close for resetting the unit.
DEMO (Demonstration) mode
When the AC cord is connected for the first time, the display
window demonstrates the functions of the unit. When the power
is turned on, the DEMO display is overridden by the operation
display. When the power is turned off, the DEMO mode is
restored.
To cancel
DEMO
mode
Press the DEMO button. To reenter, press again.
Illumination guide
Whenever the AC cord is connected or one of the function buttons
is pressed, the buttons for that operation light up or flash.
Example: When connecting the AC cord, the II SET button
flashes to guide in setting the current time.
Flash window
The window on the top of the unit lights up or flashes while the
power is turned on.
To turn off, press the CLEAR button while pressing the CD
button. To turn back on, repeat the above.
Do not perform this operation during recording.
After use
Press the POWER button to turn off the power. The display
changes to the clock.
Using the headphones
Connect headphones to the PHONES jack with a stereo standard
plug (06.3 mm,
1/4
inch).
No sound is output from the speakers while the headphones are
plugged in,
REMOTE CONTROL
Inserting batteries +
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
When to replace the batteries
The maximum operational distance between the remote control
and the sensor in the display window should be approximately 5
meters (16 feet). When this distance decreases, replace the
batteries with new ones.
If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
The remote control may not operate correctly when:
- the line of sight between the remote control and the remote
sensor is exposed to intense light, such as direct sunlight.
- other remote controls are used nearby (television, etc.).
12