G/A (Group/Aux) Send 1~8 Block; Main Out Block; Pan]/[Csr] Control; Send Level Controls - Yamaha PM 5000 Owner's Manual

Input Channel Section

G/A (Group/Aux) Send 1~8 Block

These controls determine how the channel signal is sent
to the console's 8 group/aux buses.

$ Send Level Controls

Adjust send level to the corresponding group/aux bus (0
dB at approximately 2 o'clock).
% [ON] Switch
When an [ON] switch is engaged the send to the
corresponding group/aux bus is active.
^ [PRE] Switch
When this switch is engaged the pre-fader signal is sent
to the corresponding group/aux bus. When off, the post-
fader signal is sent to the group/aux bus.
NOT E
The above descriptions apply when the group/aux buses are used
as 8 mono aux buses (the default mode). The functions of the
controls will vary depending on the G/A bus mode selected via
the group/aux master section – refer to "Group/Aux Switching"
on page 32 for details.
18
$
%
^

Main Out Block

This block determines how the channel signal is
assigned to the console's main stereo and mono (center)
buses. The stereo and mono outputs can be used
independently, or combined for LCR output.
Mono Input
Module
&
(
¡
º
& [PAN]/[CSR] Control
(mono modules only)
Adjusts panning of the signal sent to the bus(es) to which
the channel signal is assigned via the main out switches
(. When the [ST] switch is engaged, assigning the
channel signal to the stereo bus, stereo panning is
adjusted via the inner control. When the [LCR] switch is
engaged and the channel signal is assigned to both the
stereo and mono buses in LCR mode, the outer [CSR]
(Center-Side Ratio) control can be used – refer to the
column below.
* [BAL] Control (stereo modules only)
Determines the stereo balance when the stereo-module
[ST] main out switch is engaged to send the channel
signal to the stereo bus.
Stereo Input
Module
*
(
¡
º