Table of Contents
Advertisement
WAN Frame Relay Config
This screen allows you to specify which WAN 1 or WAN 2 Frame Relay is to be configured by highlighting the
desired entry below and then hitting <Enter>. Next, enter a Data Link Connection Identifier (DLCI) between 16
and 991 and Enable it in the State field on the following screen. Additionally, you must choose the appropriate
Switch Type on the WAN Frame Relay Config screen below to complete the WAN Frame Relay configuration.
The parameter is described below:
Switch Type – This allows you to choose Local Management Interface (LMI) specification. Currently, we
support ANSI T1.617 Annex D and ITU Q.933 Annex A specifications. This switch type must be configured to
match your Frame Relay subscription. Once a change has been made, the router must be rebooted.
21
DI-1162/DI-1162M Remote Access Router
Advertisement
Table of Contents
