Installation; Overview; Other Resources; Packing List - D-Link DI-1162M User Manual

D-link remote access router user's guide
Table of Contents

Advertisement

DI-1162/DI-1162M Remote Access Router

Installation

This chapter details installation procedures for the DI-1162/DI-1162M router.

Overview

The DI-1162/DI-1162M can be configured in two ways; through a direct serial connection (a console), or
remotely, through the included Router Configuration Utility, Telnet, etc. Please note that if you wish to remotely
configure the router, you must still use a console to initially configure the LAN or WAN port for a remote
connection.
In general, the installation procedures are as follows:
1. Physically install the router into an equipment rack or onto a desktop.
2. Configure the router through a console.
3. Power off the router and console.
4. Plug in all cables and connectors (LAN, WAN, etc.).
5. Power on all devices.
Each of the above items is discussed in detail below.
Note: Your LAN does not need to be powered down when making a LAN connection to the router via the RJ-45
port. However, when connecting devices to the WAN or Diagnostic (console) ports please make sure the router
and the other devices are turned off before making the connection.

Other Resources

For more information about your DI-1162/DI-1162M please check the following sources:
Quick Installation Guide.
Support disk containing RouteView, a Windows-based configuration program used to set up and configure
the router.
Frequently Asked Questions (FAQ) and application notes for this router can be found on the D-Link Web
site at http://tsd.dlink.com.tw/.

Packing List

Before you proceed further, please check all items you received with your DI-1162/DI-1162M Router with this list
to make sure the package is complete. The complete package should include:
One DI-1162 or DI-1162M Router.
One 100~240V AC power cord (the plug type depends on the region the router is shipped in).
One RS-232 (DB-9 to DB-9) cable for console connection.
One 6 ft. (1.83m) Category 5 UTP cable for LAN connection.
One EIA-530 (DB-25 to DB-25) cable for WAN connection.
Four rubber feet with adhesive backing.
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Di-1162

Table of Contents