Table of Contents
Advertisement
DI-1162/DI-1162M Remote Access Router
Diagnostics RS-232 Serial Port A DB-9 female connector used to connect a console to the router for initial
setup and out-of-band management.
Wan Ports (1 and 2) Two DB-25 male connectors each of which can be connected to a dial-up (dial in or out)
line or a dedicated leased line by multiplexing with a modem or CSU/DSU (Channel Service Unit/ Data
Service Unit), respectively.
Slot for Add-in Module This slot is able to house any one of the following slide-in expansion modules:
A single RJ-45 10/100 Ethernet port
Two high-speed serial (async/sync) ports
A BRI ISDN module (S/T interface only).
LAN Port This jack is a full featured RJ-45 10/100 Ethernet/Fast Ethernet port. This feature allows this port
to automatically configure itself to match the settings used by the port it is being connected to. If it is connected
LED
STATUS/ FUNCTION
Power
Lights whenever the router is plugged in, turned on, and thus
receiving power.
Diag
Lights during the startup Power-On Self-Test (POST) test.
Boot
Lights briefly during startup after the PROM program has
executed. Indicates a successful boot up.
Run
Should be slowly blinking if the router is functioning properly.
10/100
This LED is ON for a 100Mbps link, and OFF for a 10Mbps
link.
Link/Act
This LED is ON to show a good link to the LAN, and quickly
flashes to show communication activity on the line.
LAN
Full/Half
This LED is ON for a full-duplex connection, and OFF for
half-duplex.
Col
The LED flashes to show transmission collisions on the line.
Ready
This LED is ON to show a good modem or CSU/DSU link to
WANs
the WAN port.
1 & 2
Act
This LED flashes to show communication activity on the line.
Ready
This LED is ON to show a good modem or CSU/DSU link to
the WAN module, or a good link to the LAN port module.
Module
Act
This LED flashes to show communication activity on the line.
6
Advertisement
Table of Contents
