Mac Address Filters; Filter Settings; Add Mac Address; Mac Address List - D-Link GamerLounge DGL-4300 Owner's Manual

Mac Address Filters

The MAC (Media Access Controller) Address filter section is used to control network access based
on the MAC Address of the network adapter. A MAC address is a unique ID assigned by the
manufacturer of a networking device. This feature can be configured to ALLOW or DENY network/
Internet access.

Filter Settings

Enable MAC Address When this is enabled, depending on the mode selected, computers are
Filter: granted or denied network access based on their MAC address.
Mode: When Allow is selected, only computers with MAC addresses listed in the
MAC Address List are granted network access. When Deny is selected,
any computer with a MAC address listed in the MAC Address List
Filter Wireless Clients:
When this is selected, the MAC address filters will be applied to wireless
network clients.
Filter Wired Clients:
When this is selected, the MAC address filters will be applied to wired
network clients.

Add MAC Address

Enable: MAC address entries are activated or deactivated with this checkbox.
MAC Address: Enter the MAC address of the desired computer or connect to the router from
the desired computer and click Copy Your PC's MAC Address button.
Save:
Saves the new or modified MAC address in the MAC Address List. When
you are done editing the settings, you must click the Save Settings button
at the top of the page to make the changes effective and permanent.

MAC Address List

This section lists the current MAC address filters. Entries can be modified by clicking on the paper and
pencil icon. To delete an entry, click on the trash can icon. After you've completed all modifications
or deletions, you must click the Save Settings button at the top of the page to save your changes.
The router must reboot before new settings will take effect. You will be prompted to Reboot the
Device or Continue. If you need to make additional settings changes, click Continue. If you are
finished with your configuration settings, click the Reboot the Device button.
39
Using the Configuration Interface
Advanced > MAC Address Filter
D-Link Systems, Inc.