Connecting Microphone And Headphones; Connecting The Power Cord - Pioneer DJM-800 Operating Instructions Manual

CONNECTIONS (CONNECTING MICROPHONE AND HEADPHONES/CONNECTING THE POWER CORD)

CONNECTING MICROPHONE AND HEADPHONES

Microphone
The MIC 1 jack on the upper surface of the operating panel can be
used to connect a microphone with Ø6.3 mm phone plug or XLR
plug.
The MIC 2 jack on the upper surface of the operating panel can be
used to connect a microphone with Ø6.3 mm phone plugs.
¶ When the connection panel's MIC SIGNAL switch is set to [CUT],
no microphone sounds will be output from the BOOTH monitor
output connectors.
¶ When using a microphone, set the operating panel's MIC switch to
[ON] or [TALK OVER], and adjust the LEVEL dial as necessary.
When not using a microphone, it is recommended to set the MIC
switch to [OFF] and rotate the LEVEL dial fully counterclockwise to
the [- ∞] side.
Microphone 1
(Microphone 1)
Microphone 2

CONNECTING THE POWER CORD

Connect the power cord last.
÷ After completing all other connections, connect the accessory power cord to the AC inlet on the back of the player, then connect the plug to a
standard wall outlet or to the auxiliary power outlet of your amplifier.
÷ Use only the supplied power cord.
8
MIC
MIC 1 MIC 2
MIC 1
LEVEL
0
MIC 2
LEVEL
0
HI
+
-
12 6
EQ
LOW
- +
12 6
MIC
OFF ON TALK
OVER
Headphones
The PHONES jack on the upper surface of the operating panel can be
used to connect headphones with a Ø6.3 mm stereo phone plug.
Headphones
HEADPHONES
MONO SPLIT STEREO
MIXING
CUE MASTER
LEVEL
0
PHONES