Connecting To The Water Supply; Connecting To The Drain - Beko WMB91242L Installation & Operating Instructions And Washing Guidance

Connecting to the water supply.

Important:
• The water supply pressure required to
run the machine must be 1-10 bar (0,1
– 1 MPa). (Practically, it is necessary
to have 10 – 80 liters of water flowing
from the tap in one minute to have
your machine run smoothly.) Attach a
pressure-reducing valve if the water
pressure is higher.
• Connect the special hose supplied with
the machine to the water intake valves
on the machine.
• In order to prevent water leakage that
may occur at the connection points,
there are rubber seals (4 seals for the
models with double water inlet and 2
seals for other models) attached to the
hoses. These seals should be used at
the tap and machine connection ends
of the hoses. The plain end of the hose
fitted with a filter must be attached to
the tap and the elbowed end must be
attached to the machine. Tighten the
nuts of the hose well by hand; never
use wrenches to tighten the nuts.
• Open the taps completely after making
the hose connection to check if there
is any water leakage at the connection
points. Turn off the tap and remove the
nut in case of any leakage. Retighten
the nut carefully after checking the seal.
To prevent any water leakage and any
other damage to be caused by it, keep
the taps closed when the machine is
not in use.
• Models with a single water inlet should
not be connected to the hot water
tap. Laundry may be damaged or the
appliance may switch to protection
mode and not work.
When returning the appliance to its place
after maintenance or cleaning, care should
be taken not to fold, squeeze or block the
hoses.

Connecting to the drain

The water discharge hose can be attached
to the edge of a washbasin or waste water
system. The drain hose should be firmly
fitted into the drain as to not loosen in its
housing.
Important:
• The end of the drain hose can be
directly connected to the wastewater
drain or to the washbasin. The
fitting must be secured in all types
of connections. Your house may be
flooded if the hose falls out of its
housing during water discharging.
• The hose should be attached to a
height of at least 40 cm, and 100 cm at
most.
• In case the hose is elevated after
laying it on the floor level or close to
the ground (less than 40 cm above the
10 - EN