Beko WMA510 Manual page 8

Detergent and softener dispenser
1 Open the drawer.
2 Put powder detergent and the fabric
softener in the compartments as shown.
3 Close the detergent and softener drawer.
Detergent compartment II
for fabric softener for wash cycle
Syphon
Powders and liquids
The performance of the washing machine
depends on the effectiveness of the detergent.
Stains can remain if low quality detergents are
used.
• Only use powders specific for automatic
washers, otherwise over foaming and poor
washing performance will be experienced.
• Do not use liquid detergent in your detergent
drawer. Only use liquid detergents with a
dosing ball.
• Do not attempt to use detergents and
bleaching agents that contain chlorine and
sulphur.
• Concentrated softener may clog the syphon,
in this case add some water to the softener
liquid.
Amounts
Follow the manufacturer's recommended
amount of detergent given on the packaging.
Adjust the amount according to the dirt
level, the amount of fabric and the softness of
the water. For example, if a small amount of
clothing is washed, put in half the amount of
detergent normally required.
• Do not fill the fabric softener above the max
mark as any excess amount will mix into
the wash water and you will have to re-fill
the compartment.
Detergent compartment I
for prewash cycle
W M
Starting
Attention!
Before any operation of the machine check
the following:
• Have you closed the front door?
• Are the taps open?
• Is the drain hose placed and secured
properly?
• Is power connected?
To start the programme, press the On/Off
button. The indicator will light and the closed
door will be locked in a few seconds. The
programmer knob will rotate and advance
to the correct point to commence washing.
This is a normal function of the
programmer.
1 2 3 4 5
Cold
90° 90° 60° 40°
6 7 8 9
60° 50° 40° Cold
Woollens 10 11
40° Cold
B
Programme operation
During the machine's operation, the
programme selection knob turns clockwise and
follows the programme steps.
1, 2, 3, 4, 5 and A programmes end on the
line after A.
6, 7, 8, 9 and B programmes, if rinse hold
button is not pressed, end on the line after B.
10, 11,12 and C programmes, if rinse hold
button is not pressed, end on the line after C.
If fabric softener is added in the softener
compartment, it will be used in the last rinse
cycle.
If rinse hold is selected, by re-pressing this
button, you can continue the program. If no
spin is desired, you should leave the rinse hold
button pressed in. Turn off the machine, select
the letter D on the programme selection knob
and turn on the machine. During this operation,
water in the machine will be discharged.
Unloading
The machine stops automatically after
programmes are completed.
1 Press the On/Off knob to turn off your
machine.
2 The door can be opened by gently
pulling the door open handle 1-2
minutes after the washing cycle is
completed. Turn off the taps.
3 Unload the machine, and leave the door
open to air the interior.
9