Beko WMA510 Manual page 12

Pump filter warning
When the appliance is in use and depending
on the programme selected there can be hot
water in the filter. Never remove the filter
during a wash cycle, always wait until the
appliance has finished the cycle, and is empty.
When replacing the filter, ensure it is securely
retightened so as to stop leaks and young
children being able to remove it.
Hoses
To prevent any leakage, check the hoses
every two years. If the machine is placed in
cold ambient temperatures, the water
remaining inside the pump and hoses should
be drained to prevent freezing, empty the
water intake hoses by disconnecting from taps.
Drum
Do not leave any metal objects (pins, needles,
etc.) inside the drum. These objects may cause
rust on the drum surface and stain clothing.
Do not clean the drum with abrasive materials.
Cleaning the pump filter
Warning
When the appliance is in use and depending
on the programme selected there can be hot
water in the filter. Never remove the filter
during a wash cycle, always wait until the
appliance has finished the cycle, and is empty.
When replacing the filter, ensure it is securely
retightened so as to stop leaks and young
children being able to remove it.
To prevent objects entering the pump and
causing damage, your machine employs a filter
system that extends the pump life. It is advisable
to clean the filter every 30-40 washes. Before
opening the filter door, disconnect the power.
Turn the opening of kick plate screws 90° with
the help of a screw driver or a coin. Place a
little pan in front of the filter door to catch the
small amount of water spilling from the
machine. Remove the filter by turning in an
anti clockwise direction. After cleaning the
filter, replace it by turning clockwise making
sure that it is closed firmly. Replace the kick
plate and secure it by the locking screws.
Attention!
Ensure the machine is empty of water
before removing the filter. If the filter has
not been replaced correctly water will leak
out from the filter.
13