Table of Contents
Advertisement
care and maintenance
Detergent dispenser
It is necessary to remove the detergent
dispenser drawer from time to time to clean
away residue and ensure correct operation.
To remove
Pull out the drawer and press down on the
coloured insert to release it fully from its
housing. Wash the drawer in warm water to
remove detergent residue and before replacing
wipe out the housing.
Syphon
The syphon (coloured insert in the dispenser)
must be cleaned every 30-40 washes. Remove
the dispenser drawer and lift out the syphon
and wash in warm water to remove any
softener residue. Refit ensuring that the syphon
is correctly fitted before use.
Maintenance wash
If you regularly use low temperature
programs, certain detergents cause build up
of greasy deposits over time. We recommend
a hot maintenance wash once every 6 months
to clear such accumulation of residue.
Simply run the wash programme "2"
without laundry using the usual amount of
detergent.
Water intake filter
At the end of the water intake connection
and water inlet hose-tap side there are filters.
These filters prevent any dirt and objects
passing into the machine. It is advisable that
these filters should be cleaned every 30-40
washes. To clean these filters, first turn the tap
off. Then, disconnect the hose and clean the
filter with a thin brush. If the filter is very dirty,
you may clean it by pulling out with pliers. To
clean the filter at the tap side of the hose, pull
it out by hand and clean the filter under tap
water. Ensure that the sealing rings are in place
before reassembly.
12
HOT
COLD
Hide quick links:
Advertisement
Table of Contents
