Electrical Connection - Beko WMA510 Manual

Make sure that you have an earthed power
outlet socket rated at 13 amps (minimum).
Attention!
If you use your machine as built-in, the
socket must be reachable after installation, or
a separate switch (which can disconnect the
two poles) must be used in the installation.
Connect the power cord to the appropriate
electrical socket with an equivalent current
rating indicated on the rating plate at the front
of the machine behind the kick plate.
After removing the plug from its transit
position, please insert the plug seal to prevent
water spillage entering the machine.
Electrical requirements
Before you insert the plug into the wall
socket make sure that the voltage and the
frequency shown in the rating label corresponds
to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a suitable
switched and fused socket in a readily accessible
position.
Should the mains lead of the appliance
become damaged or need replacing at any
time, it must be replaced by a special purpose
made mains lead which can only be obtained
from a Beko Authorised Service Agent.
Warning
This appliance must be earthed
If the fitted moulded plug is not suitable for
your socket, then the plug should be cut off
and an appropriate plug fitted.
Destroy the old plug, which is cut off as a
plug with a bared cord could cause a shock
hazard if inserted into a socket elsewhere in
the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the fuse need
to be replaced an ASTA approved BS1362 fuse
of the same rating must be used. Do not forget
to refit the fuse cover. In the event of losing
the fuse cover, the plug must not be used until
a replacement fuse cover has been fitted.
Colour of the replacement fuse cover must be
the same colour as that visible on the pin face
of the plug. Fuse covers are available from any
good electrical store.

electrical connection

Important
Fitting a different plug
As the colours of the wires in the mains
lead of this appliance may not correspond with
the coloured markings identifying the terminals
on your plug, proceed as follows:
1 Connect the green - yellow or green (earth)
wire to the terminal in the plug marked 'E'
or with the symbol f or coloured green
and yellow or green.
Connect the blue (neutral) wire to the
2
terminal in the plug marked 'N' or coloured
black.
Connect the brown (live) wire to the terminal
3
in the plug marked 'L' or coloured red.
With the alternative plugs a 13A fuse must
be fitted either in the plug or adaptor or in the
main fuse box. If in doubt contact a qualified
electrician.
Green and yellow
or green
f
N
Blue or
black
L
Brown or red
7